Installation - Clas Ohlson L-BTB7-RGB-RB22 Bedienungsanleitung

Installation

1. Screw the speaker bulb into a normal E27 light socket.
2. Switch on the power to the light socket.
Instructions for use
Bluetooth connection
1. Activate Bluetooth mode on the device that you want
to connect to.
2. The speaker bulb will now appear as Speaker bulb on
your device. Select this on your device to begin pairing.
3. When the speaker bulb and the device have been
paired, the speaker bulb will emit an audible signal.
4. Playback must then be controlled from the connected
device.
Note: The speaker will automatically connect to the last
connected device if they both are on and Bluetooth is
activated on the device.
Using the remote control
1. Press [ ON ] to switch the speaker bulb on.
2. Press [ ] to increase the brightness.
3. Press [ ] to decrease the brightness.
4. Press the colour buttons (5) to select a colour.
5. Press one of the buttons (6, 7, 8 and 9) to select
a light effect.
Light effect
FLASH (6)
STROBE (7)
Without music
The colour
changes in quick
steps.
The colour
changes
steplessly.
The brightness
remains the same.
4
With music
The colour changes
in quick steps.
The colour changes
steplessly and
the bulb pulses in
time with the music.
Low brightness.