Installation Instructions; Operation - HANSGROHE 32122000 Gebrauchsanleitung, Montageanleitung

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
Do not allow the streams of the shower touch
sensitive body parts (such as your eyes). An
adequate distance must be kept between the shower
and you.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The mesh washer must be insert to protect the shower
against incoming dirt by pipework. Incoming dirt
leads to defects or/and can damage parts of the
shower; such caused faults voids all liability and
guarantee claims.
• During installation of the product by qualified trained
personnel, make sure that the entire fastening surface
is even and smooth (no protruding seams or tile
offset), that the finish of the wall is suitable to apply
the product and has no weak points.
• The shower must only be connected after a locking
valve or a bidette tap.
• To avoid cross flow, connect the shower only to
check valves, to the sanitary fittings specifically
provided for this purpose, or to fittings with integrat-
ed backflow preventers in the water connections.
• Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 0,15 MPa.

Operation

If the shower is connected to a shut-off valve, this must
be closed after every use of the shower.
4
English
Assembly (see page 31)
Technical Data
Rate of flow by 0,3 MPa:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Cleaning (see page 32)
Dimensions (see page 33)
Spare parts (see page 34)
Special accessories (order as an extra)
• special tool #95158000 (see page )
6 l/min
max. 0,6 MPa
0,1 - 0,4 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
max. 70°C / 4 min