Werbung
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting
injuries.
Children as well as adults with physical, mental and/or sensoric impairments
must not use this product without proper supervision. Persons under the
influence of alcohol or drugs are prohibited from using this product.
The product may only be used for bathing, hygienic and body cleaning
purposes.
The product may not be used as a holding handle. A separate handle must be
installed.
Do not allow the streams of the shower touch sensitive body parts (such as your
eyes). An adequate distance must be kept between the shower and you.
The hot and cold supplies must be of equal pressures.
Installation Instructions
• Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the
applicable standards.
• The plumbing codes applicable in the respective countries must be observed.
• The premounted dirt collection screen must be used to prevent dirt from entering
through the pipes. Dirt entering can affect the function and/or lead to damage
to the functional components of the fitting. Hansgrohe will not be held liable for
any resulting damage.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 5)
To adjust the hot water limiter. Using a hot water limiter in combination with a
continuous flow water heater is not recommended.
Maintenance (see page 5)
The check valves must be checked regularly according to EN 806-5 in accord-
ance with national or regional regulations (at least once a year).
Hot and cold supplies are reversed (see page 11)
Dimensions (see page 6)
Flow diagram (see page 6)
Hand shower
Bath Spout
Fault
Insufficient water
Mixer stiff
Mixer dripping
Spout temperature does not correspond with
temperature set
Instantaneous heater didn't work
2
English
Special accessories (order as an extra)
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
70°C / 4 min
Cause
- Aerator calcified, dirtyShower filter seal dirty
- Cartridge defective, calcified
- Cartridge defective
- Hot and cold supplies are reversed
- Aerator calcified, dirtyShower filter seal dirty
- Flow limiter in handshower isn't removed
Assembly (see page 4)
Spare parts (see page 7)
XX = Colors
00 = Chrome Plated
67 = Matt Black
70 = Matt White
extension #93882000 (see page 7)
Cleaning (see page 8)
Operation (see page 9)
Remedy
- Clean filter seal between shower and hose
- Exchange cartridge
- Exchange cartridge
- Install function block turned through 180º
(see page 11)
- Clean filter seal between shower and hose
- Remove flow limiter
Werbung
