Channel Search; Sound Settings; Setting The Picture - Medion MD 30325 Anleitung

After automatic storage of channels is complete, the program table will be displayed (see also
page 25). If this table is not modified further, it will close after a few minutes. The channel on
channel location 1 will appear.

Channel Search

• You can select a channel by pressing the P/CH key (on the device or on the remote control) or
by selecting the channel directly using a digit key.
• For a number with two digits first press the -/-- key.
• You can select the most recent displayed channel with the P<P/SWAP key.

Sound Settings

• You can increase or decrease the volume with the volume keys
or on the device.
• You can switch off the sound completely and switch it on again with the
off).
• You can choose between mono- and stereo reproduction, Dual I and Dual II , with the
I-II key. Dual I and Dual II can only be reproduced if the current broadcast supports
the DUAL mode (e.g. with bilingual broadcasts).

Setting the Picture

Zoom mode (
WIDE
Press on the key to switch between the following picture formats.
• Auto : the transmitted format is automatically set to the input signal.
• 16:9 : a picture in 16:9 format will be expanded to full screen
size.
• 4:3 : for undistorted display of the picture in 4:3 format.
• Panoramic : the picture is stretched on the left and right sides
to fill up the screen. In this case the upper and/or lower edges
are somewhat cut off.
• 14:9 Zoom : a picture in 14:9 format ("Letterbox") will be
expanded to the upper and lower edges of the screen.
• Cinema : a picture in 16:9 format will be expanded to full
screen size.
• Subtitle: As with the " Cinema " setting. The picture is only
shifted up, so that any subtitles or running text become visible.
• Zoom: the picture is automatically expanded to full picture
width.
key)
on the remote control
key (Switch sound
11
EN