Manual Code Search; Automatic Code Search - Medion LIFE E14008 (MD 20298) Bedienungsanleitung

If this is not successful either, then try using the search method described in the
section "Automatic search".

Manual code search

Carry out a manual search as follows:

Switch on the relevant device manually.

Briefly press the required source button (STB, DVD, VCR, AUX).

Keep the CODE button pressed for approx. three seconds until the blue LED stays
lit.

Repeatedly press the
which is meant to be controlled changes channel or responds appropriately.
The code search will begin at the four-digit number which is currently stored.

Briefly press OK to save the code.
Due to the considerable quantity of different code numbers, up to 350 different codes
are pre-programmed per device type. In individual cases it is possible that only the
most common main functions are available. The described method may not be
successful for certain models.

Automatic code search

If your device does not respond to the remote control even though you have tried all
of the codes listed for your device type and the relevant brand, then try using the
automatic search. This will enable you to find codes for brands that were not included
in the device code list.
If you would like to program the source buttons STB, DVD, VCR or AUX with a
different device than specified, then you will have to first program a code of the
desired device type during the automatic search. For example: You would like to use
the AUX button to control a DVD player. First program any code of a DVD player
from the list of codes before carrying out the following steps.

Switch on the relevant device manually.

Briefly press the required source button (STB, DVD, VCR, AUX).

Keep the CODE button pressed for approx. three seconds until the blue LED stays
lit.

Point the remote control at the device and briefly press the P+ button once.
If the device has no program function, then press the
The remote control will start the code search after six seconds and will transmit all
the codes consecutively at one-second intervals (cf. also next section). The blue
LED will light up for each transmission.

As soon as the device responds to the remote control, press OK. – If you didn't
press OK on time, you can go back to the code to which the device responded
step by step by using the P– button.
To cancel the search, press OK.
button (up to 350 times), P+ or P–, until the device
Universal remote control
button instead of P+.
15