Standards/Electro-Magnetic Compatibility; Batteries And Proper Treatment - Medion MD 30325 Anleitung

Standards/electro-magnetic compatibility

Your display fulfils the requirements for electro-magnetic compatibility and electrical safety specified
in the following standards:
EN 55013
EN 55020
EN 60065
EN 61000-3-2
EN 61000-3-3

Batteries and Proper Treatment

Batteries may contain combustible materials. By misuse, this may cause battery leakage, heat,
explosion or ignition, bring-ing about injury or damage to the device.
Please observe strictly the following matters:
• Keep children away from batteries. If by any chance, the batteries are swallowed, consult a
doctor immediately.
• Do not charge batteries (except rechargeable batteries).
• Do not forcibly discharge batteries.
• Do not short-circuit batteries.
• Do not heat or dispose off in fire. .
• Do not disassemble or deform batteries. Your hands and fingers may be injured, or the liquid of
the battery may get into your eyes or adhere to your skin. If this happens, rinse with a large
quantity of water immediately and consult a doctor.
• Do not expose batteries to strong impact by dropping or throwing the batteries.
• Do not reverse the positive (+) and negative (-) terminals to avoid short-circuit.
• Do not mix used and new or different types of batteries together.
• Remove promptly the used batteries from the device.
• Remove the batteries from your device if it is not to be used for a longer period.
• Clean the battery and device contacts, if necessary, before inserting batteries.
• Replace all batteries with new batteries of the same type at the same time.
8
Limit values and measuring methods for radio interference by radios and
television receivers and accessories
Electromagnetic immunity of broadcast receivers and associated equipment
Audio,video and similar electronic apparatus—Safety requirements
Electromagnetic compatibility (EMC)—Part 3-2:Limits—Limits for harmonic
current emissions (equipment input current up to and including
16 A per phase)
Electromagnetic compatibility (EMC)—Part 3-3:Limits—Limitation of voltage
changes,voltage fluctuations and flicker in public low-voltage supply
systems,for equipment with rated current <= 16 A per phase and not subject
to conditional connection