Attaching Door Handles - hanseatic HKGK 20060A3NFI Gebrauchsanleitung

Page EN-22 Set-up

Attaching door handles

(j)
1. Unscrew the blind plugs (j) from both
doors.
(k)
(l)
2. Attach the door handles (m) to both doors
using the enclosed screws (k).
3. Cover the screw heads with the enclosed
blind plugs (l).
Diagram: space requirement (door open)
– To prevent the formation of a flammable
gas-air mixture in the event of a leakage
in the refrigeration circuit, the installation
space must have a minimum size of 1 m
per 8 g of refrigerant in compliance with
the EN 378 standard. The amount of re-
(m)
frigerant contained in your appliance can
be found on the type plate and on the data
sheet at the end of this user manual.
The minimum size of the area in which your
appliance is set up is as follows: 5.25 m³.
– The appliance must only be placed on a
level and firm surface. The surface must be
strong enough to support the appliance's
weight when fully laden.
– Suitable locations are dry, well-ventilated
areas that are cool if possible.
– Unsuitable locations are ones with direct
sunlight or which are directly next to an
oven, hob or radiator.
– If underfloor heating is installed at the set-
up location, place the cooling appliance on
an insulation plate made from solid material.
595mm
135°
1033mm
3