Gossen MetraWatt ProfiSafe 1 Bedienungsanleitung Seite 13

5 Characteristic Values
Display:
Rated voltage range:
Frequency range:
Current (peak value):
Input resistance:
On-time:
Continuity test:
Over-voltage category:
Housing:
Connecting cable:
6 Maintenance
6.1 Testing and charging the storage battery
To test the functions and your own energy source,
hold the test electrodes together.
The rectangular green LED (continuity test) must
light up for 5 seconds.
If the green LED does not flash or light up when
putting together the test probes, you have to
recharge the battery. To recharge the battery,
place the device in a light source (e. g. on a win-
dow sill) with the display field facing up. Due to the
highperformance solar cell, the ProfiSafe 1 will be
fully functional within a short period of time
(approx. 5 minutes).
Perform the function test before putting the instru-
ment back into operation (see 3.1).
Attention!
Please do not use halogen lamps for charging,
otherwise the device could be damaged.
6.2 Housing
The voltage tester should be kept dry and clean.
The plastic housing can be cleaned with a cloth
dampened with isopropyl alcohol or soapy water.
GOSSEN METRAWATT GMBH
9 LED's for voltage,
continuity, phase
and phase
sequence
12...690 V AC/DC
in steps 12, 50,
120, 230,
400 and 690 V
0...2000 Hz
3.1 mA (690 V)
223 kΩ
30 s
0...200 kΩ constantly
gleaming,
0.2 ...3 MΩ flashing
CAT IV
ABS, IP 65
Rubber insulated
flexible cable
H07RN-F, 1m
6