Faults And After-Sales Service - NEFF F 3470 Gebrauchsanleitung

Fitting the shelf support

Faults and after-sales service

Fault
The appliance is not working.
The clock display is flashing.
The oven light is not working.
To refit the shelf support, proceed as follows:
1.
Position the bottom part of the shelf support on the
respective pins.
2.
Push the upper part against the oven side wall until
it hooks into the upper pin.
If a fault occurs, it is often only due to a small thing.
Before calling the after-sales service, please see the
following notes.
Possible cause
Defective fuse
Power failure
Power failure
Defective oven light
bulb
Repairs must only be carried out by trained
after-sales service engineers.
If your appliance is not properly repaired, this may
cause serious risks to you.
Notes on remedial action
Check in the fuse box that
the fuse for the appliance is
in order.
Check whether the kitchen
light is working.
Reset the time.
Replace the oven light bulb.
(see the following section
"Replacing the oven light
bulb")
77