Operation / Settings; Operation And Maintenance - GRAPHITE 59G206 Bedienungsanleitung

Disc lock button (1) can be used only for installation and removal of the disc. It cannot be used as a
brake-button while the disc is rotating, otherwise the grinder may be damaged or the user may be
injured.
Check the grinding disc before using the grinder. Do not use discs with dents, cracks or other
damages. Replace immediately worn out disc or brush. After work is finished always turn the
grinder off and wait until the disc stops completely. Only then you can put the grinder away.
● Do not overload the grinder. Weight of the power tool makes enough pressure. Overloading and
too strong pressure may cause dangerous crack of the working tool.
●
Always replace working tool after the grinder is dropped during operation.
●
Never hit processed material with working tool.
●
Avoid kick-backs and tearing off material with the disc, especially when processing corners, sharp
edges etc. It may cause loss of control of the tool and occurrence of the kick-back.
●
Never use wood-cutting discs designed for circular sawing machines. Use of such discs often
results in tool kick-back, loss of control and to operator injury in consequence.
SWITCHING ON / SWITCHING OFF
Hold the grinder with both hands when starting and operating the tool. The grinder is equipped with
the switch, which protects against accidental starting.
●
Move the lever switch (
●
Press the switch button (
●
Release pressure on the switch button (
Wait a while after starting the grinder until the disc reaches its top speed, only then you can
proceed with your work. Do not use the switch during operation of the grinder to switch it on or off.
Switch button may only be used when the power tool is away from the processed material.
Unplug the power cord from mains socket before commencing any activities related to installation,
adjustment, repair or maintenance.
●
Do not use water or other liquids to clean the grinder.
●
Use brush to clean the grinder.
●
Clean ventilation holes of the grinder regularly to prevent motor overheating.
●
Make periodic breaks in operation.
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes.
Always replace both brushes at a time.
●
Unscrew the brush covers (
●
Remove used brushes.
●
Remove any carbon dust with compressed air.
●
Insert new carbon brushes (
●
Brushes should easily move into brush-holders.
●
Install brush covers ( 8).
After the brushes are replaced start the grinder idle and wait until the brushes fit to the motor
commutator. Entrust replacement of carbon brushes to a qualified person. Use only original parts.
All faults should be repaired by service workshop authorized by the manufacturer.

OPERATION / SETTINGS

7) to the front.
2) (fig. C).
2) to stop the grinder.

OPERATION AND MAINTENANCE

8) (fig. E).
fig. F).
13