Amprobe TMD-55 Bedienungshandbuch Seite 20

point can be saved in one log session. Press the "
button again to exit the data log function.
The CLR function clears all the saved and logged data in
memory. When the " " button is pressed, indicator
" " is displayed and the "
will blink. Pressing the "
overlay in white will clear all saved and logged data. Press
" " button to exit this function without clearing data.
The relative value function can be used for comparing the
saved reference value with other measurements. Press the
" " button to store the current measurement as the
reference value, and " " should be displayed on the
right part of the LCD. The next measurement will display
the current value compared to the reference value. Press
" " button again to clear the reference value and
deactivate the relative value measurement function.
Press the " " button to turn the "
function on or off. When this function is enabled, the
indicator " " is shown at the upper left part of the
LCD.When APO (Auto power off) is enabled, it will
automatically turn the thermometer off no button is
pressed for a period longer than the set time interval (the
default time for APO is 5 minutes). Press power button to
resume operation.
Press this key to change the type of thermocouple in the
main display (K/J/T/E/R/S/N). If the inputs of the main and
second display are the same, then pressing this key will
change the thermocouple type for both displays.
13
"
" on upper-right of LCD
" button printed on the
"