Werbung
Notices
General Information
Safety
Before commencing any work on the product,
carefully read through the operating instructions
from start to finish, in particular the section entitled
"Safety" and the related safety advice. It is
important for you to have understood what you
have read. This product could prove hazardous if
not used properly as directed or in accordance with
the regulations.
Any damage occurring as a result of noncompliance
with these instructions shall render the
manufacturer's liability null and void.
Explanation of the symbols
WARNING: imminent danger
This symbol indicates that instructions are
being given which, if not observed,
could lead to serious injury
WARNING: DANGER DUE TO ELECTRIC
VOLTAGE. The works have to be done by an
electrican.
Attention ! This symbol indicates that
!
instructions are being given which, if not
observed, could lead to malfunctions and / or
failure of the operator.
Working safety
By complying with the safety advice and
information provided in these Operating
Instructions, injury to persons and damage to
property whilst working on and with the product
can be avoided.
Failure to observe the safety advice and
information provided in these Operating
Instructions as well as the accident prevention and
general safety requirements relevant to the field of
application shall exempt the manufacturer or its
authorized representatives from all liability and
shall render any damage claims null and void.
Hazards that may emanate from the product
The product has been subjected to a risk
assessment. The design and execution of the
product based on this corresponds to state-of-theart
technology.
When used properly as intended, the product is
safe and reliable to operate.
Nevertheless, a residual risk will always remain!
The product runs on a high electrical voltage.
Before commencing any work on electrical
systems, please observe the following:
1. Disconnect from the power supply
2. Safeguard to prevent a power restart
3. Check that the electricity supply is cut off
Producer:
Novoferm tormatic GmbH
Oberste-Wilms-Str. 15a
D-44309 Dortmund
Spare parts
Only use genuine spare parts of the
manufacturer.Wrong or faulty spare parts
can cause damage, malfunctions or even
a total failure of the product.
Dismantling
Dismantling takes place in reverse sequence to the
Installation Instructions 7- 1.
Changes and modifications to the product
To prevent hazards and ensure optimum
performance, no changes, modifications or
conversions may be made to the product that have
not been expressly approved by the manufacturer.
Disposal
Observe the corresponding country-specific
regulations.
Data plate
The data plate is located under the control panel
cover. Observe the specified power rating.
Packaging
Always dispose of the packaging in an
environmentally-friendly manner and in
accordance with the local regulations on disposal.
GB
Werbung
