Switching On And Off; General Working Instructions; Use As A Grass Trimmer; Use As A Hedge Trimmer - FLORABEST FGS 3.6 B2 Originalbetriebsanleitung

GB IE NI

Switching on and off

1. Remove the blade guard (12/14)
before switching the unit on.
2. Insert the safety key (7) into the
device.
3. To switch on, hold the switch lock
(2) depressed and operate the
on/off switch (8). Then release
the switch lock.
The equipment runs at top speed.
4. In order to switch off, let go of the
on/off switch (8).
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come
to a complete standstill. Do not
touch the blades or slow them
down before the moving parts
have come to a standstill.

General working instructions

While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to
cutting head damage. If the blades
become blocked by solid objects,
switch off the unit at once.
• Check the grass and bush trimmer
blades for obvious defects such as
loose, worn or damaged parts. Check
that the screws are seated firmly in the
blade block.
• Remove the power supply unit (
before working with the equipment. Do
not use extension cables. The power
supply unit is to be used only in en-
closed spaces.
• Only use sharp blades to achieve a
good cutting performance and preserve
14
CY
15)
the battery.
• Do not work the unit so hard that it
comes to a standstill.
• Pay attention to the instructions on unit
maintenance and cleaning.

Use as a grass trimmer

• Grass is best cut when dry and not too
long.
Adjusting the working angle
For a comfortable edge cut, the cutter head
(1) can be rotated by 90° to the right or left.
1. Operate the lever (3) and turn
the cutter head (1) into the de-
sired position.
2. Release the lever (3), the cutter
head locks into place.

Use as a hedge trimmer

• Move the unit forward evenly.
• The double-sided cutting heads enable
cutting in both directions or by swing-
ing the unit from side to side.

Cleaning/Maintenance

Leave any work not covered
in this manual to our Service
Centre. Only use original
parts. There is a risk of injury!
Ensure that the safety key (
removed before all tasks.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
7) is