Operation; Switching On And Off; General Working Instructions; Use As A Grass Trimmer - FLORABEST FGS 10 A1 Originalbetriebsanleitung

1. Insert the two sections of the
telescopic shaft (20, see small
image) into each other. Ensure
that the cable is not caught.
2. Insert the end of the telescopic
shaft (20) into the opening (9)
provided on the rear on the
unit handle (1) until it clicks into
place. The pole can be attached
in 8 positions (each at a 45° an-
gle offset). Select the setting that
is most suitable for you.
3. Adjust the length of the telescop-
ic shaft (20) to your body height
using the height-adjustment
screw (18).
4. The unit can now be switched
on and off (16) after moving the
off-lock switch (15) at the handle
(17) of the telescopic shaft (20).
5. To dismantle, press the safety
button (19) and pull the telescop-
ic shaft (20) out of the unit.

Operation

Keep to noise abatement regula-
tions and other by-laws.

Switching on and off

1. Remove the blade guard
(10/13) before switching the unit
on.
2. To switch on, move the off-lock
switch (3) forwards. While keep-
ing the off-lock switch forward,
switch the unit on at the on off
switch (2) and let go of the off-
lock switch. The unit will run at
its highest speed.
3. In order to switch off, let go of
the on/off switch (2).
When using the telescopic shaft (20), the
unit can only be switched on and off at
the shaft handle.
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come
to a complete standstill. Do not
touch the moving blades and
do not try to stop them moving.
Injury hazard!

General working instructions

While trimming, take care that
there are no objects such as wire,
metal parts, stones etc. come into
contact with the blades. This can
lead to cutting head damage. If the
blades become blocked by solid
objects, switch off the unit at once.
• Check the grass and bush trimmer
blades for obvious defects such as
loose, worn or damaged parts. Check
that the screws are seated firmly in
the blade block.
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.
• Do not work the unit so hard that it
comes to a standstill.
• Pay attention to the instructions on
unit maintenance and cleaning.

Use as a grass trimmer

Assembling/Removing the Wheels:
• To mount the wheels (5), as-
semble the lateral axle (23) into
the both guidance elements (24)
at the underside of the tool and
push it down. You will hear the
Gb MT
55