Helios EUR EC Montage- Und Betriebsvorschrift Seite 185

Installation and Operating Specification EUR EC
11 14 12
K1
Function
1K
2K
3K
4K
5K
6K
7K
Factory assignments: Virtual outputs / actual outputs
Virtual output
DO1
DO2
DO3
DO4
DO5
DO6
Inverting
DO1
OFF
Inverting
L-BAL-E274-GB 1815 Index 002
K1
21 24 22
K2
11.05.2007
K2
v_relais_k1_k2.vsd
Controller status
Operation without fault, line supply okay
Fault with indication by relay
External Fault at digital input for external fault
Exceeding or falling below modulation
over or falling below limits for input signal "E1"
over or falling below limits for input signal "E2"
setpoint deviation to high
Actual output
Signal
Signal
Inverting
The inversion of the relays "K1" and "K2" is set at the factory to "OFF" (when a function
is programmed).
For switching inversion to "ON" (switching behaviour dependent on assigned function).
The relays can only pull up basically when the voltage supply of the electronics is
working. Three-phase current devices must have at least 2 line phases!
1 = energized, terminals 11-14 bridged
0 = de-energized, terminals 11-12 bridged
1 = energized, terminals 21-24 bridged
0 = de-energized, terminals 21-22 bridged
Explanation
K1
K1 MODBUS Master
K2
K2 MODBUS Master
not available
n.a.
(no output assigned)
not available
n.a.
(no output assigned)
not available
n.a.
(no output assigned)
not available
n.a.
(no output assigned)
Part.-No.
68/116
Programming
K1/ K2
1 = energized
0 = de-energized
Inverting
OFF ON
1
0
0
1
1
0
1
0
1 0
1
0
1 0