Helios EUR EC Montage- Und Betriebsvorschrift Seite 148

Installation and Operating Specification EUR EC
Base setup
OFF
E2 Function
L-BAL-E274-GB 1815 Index 002
E2 Function
The second signal input is not activated at the factory for modes with one sensor.
The function is automatically jointly programmed in operating modes using 2 sensors.
The second analog input is thus allocated and additional function allocations are not
possible.
|
2.04
4E
E2 Function at
•
higher temperature. Alternative: average of 2 measuring points for this must be
reprogrammed on function
|
2.05
5E
E2 Function at
•
between sensor 1 and sensor 2. Preprogrammed sensor type
"E2 Function"
Adjustable
• | |
1E
= External Setpoint e.g. via external signal (0 - 10 V) instead of
"E1 Analog In"
– For sensor type
– For sensors with active signal: 0 - 10 V
• | |
2E
= External manual operation via external signal (0 - 10 V). Switching between
setting on the device and external manual operation via digital input (
| |
7D
Function ).
• | |
6E
= sensor for outdoor temperature-dependent setpoint adaptation (at
possible), pre-programmed sensor type
– additional parameters menu group
– additional parameters menu group
– Example Setting for operation
• | |
7E
= Measurement value = Measurement value e.g. for limit indication, display in
"E2 Actual"
Info menu .
• | | | |
8E 13E
... = sensor input for control circuit 2 (at
setup / operation with second control circuit.
Part.-No.
31/116
|
preprogrammed = comparison value with control to
| |
3E
preprogrammed sensor type
|
preprogrammed = regulation on difference temperature
"TF or PT1000"
=
0 - 100 % sensor measuring range.
"TF.." .
: T-Band, T-Start SA, Min. Setpoint.
"Setting"
: Setpoint Control
"Info"
4.01 4.02
+ / additional menu items.
2.03
Programming
"TF" .
"TF" .
"Setpoint 1"
: 0 - 10 V -50.0...+150 °C.
IO Setup:
2.03
not
not possible) base