Helios EUR EC Montage- Und Betriebsvorschrift Seite 164

Installation and Operating Specification EUR EC
Info
0 °C
Setpoint1
Info
100.0 Pa
Setpoint control
Info
0 %
Brake control
Info
OFF
Min. speed cut off
L-BAL-E274-GB 1815 Index 002
Display of the active target value at which the device operates.
"Setpoint1" Menu "Setting"
"Setpoint2" Menu "Setting"
"Ext. Setpoint" = setting by external signal 0-10 V. With activated manual mode the
display constantly changes between actual value and value for manual mode.
Display for operation with two control circuits:
"1.Setpoint 1" or "1.Setpoint 2" for control circuit 1
"2.Setpoint 1" or "2.Setpoint 2" for control circuit 2
Only for mode 4.02 , with setpoint depending on outdoor temperature (E2 function =
| |
6E ).
Level modulation control output.
In addition to the bar chart, the level of the output voltage is indicated.
The modulation for each control circuit is displayed in operation with two control
circuits:
"1. Modulation" for control circuit 1
"2. Modulation" for control circuit 2
Momentarily status for minimum speed cut off
"ON" = switch off, if Setpoint (+/- "Min. speed cut off") is reached.
"OFF" = no switch off that means operation with minimum rate of air.
Display for operation with two control circuits:
"1. Min. speed cut off" for control circuit 1
"2. Min. speed cut off" for control circuit 2
Part.-No.
47/116
Programming