Absolute Humidity Difference Control; Base Setup 8.01 - Helios EUR EC Montage- Und Betriebsvorschrift

Installation and Operating Specification EUR EC
Base setup
OFF
Manual mode
Base setup
100 %
Speed manual
9.5

Absolute humidity difference control

Information
For further information, see appendix Basic principles / Setting options for "Absolute humidity
difference control".
9.5.1 Base setup
Main menu
Start
Setting
Protocol
Base setup
Controller Setup
Base setup
8.01
Mode
Base setup
AFS 0-10V
E1 Analog In
Base setup
0.0 g/kg
E1 Offset
L-BAL-E274-GB 1815 Index 002
Manual mode
"OFF" = automatic control as function of the set parameters (Factory setting)
"ON" = automatic control without function, speed setting in menu "Speed manual"
Speed manual
Manual speed setting without influence by the external signal.
Activation by menu "Manual mode" or external contact at digital input (
Setting range: 0...100 %
Factory setting: 100 %
For information about deactivated regulation the adjusted value for manual speed is
indicated alternating with the actual value.
8.01
Base setup
Mode
Mode selection
E1 Analog In
The sensor input is factory set for mode
Measuring range: 0...50.0 g/kg
Output signal: 0 - 10 V
Connection terminals: "E1", "GND", "24V"
Input for sensors with free measuring range and linear characteristic curve adjustable
for the following standard signals:
0 - 10 V, 0 - 20 mA, 4 - 20 mA
For sensors with free measuring range, the sensor measuring range must be entered
under the following menu points in order to ensure a correct actual value display: E1
unit, E1 decimal, E1 Min., E1 Max.
E1 Offset
Sensor calibration with calibrated comparison device.
The current "E1 Actual" is displayed including the offset set here.
"Min. Speed"... "Max. Speed"
8.01
8.01
8.01
Part.-No.
42/116
Programming
to sensor type "AFS 0-10V".
IO Setup).