Setting Up The Camera - Bosch FlexiDome XF VDC485V03-10 Installationshandbuch

FlexiDome
XF & DN

Setting up the camera

Warning: Hot Surface
The Heater will be HOT when in operation - DO NOT TOUCH.
Always switch the heater OFF, when working on the camera.
Refer to the installer menu (see Menu Structure) for instructions.
You can connect a monitor to the miniature 2.5mm jack socket on the
printed circuit board to help set up the camera. This socket provides a
composite video signal (with sync). An optional cable (code number
S1460) is available for making this connection.
Heater
Monitor jack
Bosch Security Systems | 2005-10 | V1.0
| Installation Manual
Focus
Thumbwheels
EN | 13
Focal length
Navigation
switches