Mounting Steps With Straining; Mounting Steps With Screwed - VEGA VEGAWELL S 51 Betriebsanleitung

Information:
For this purpose, we recommend
VEGABOX 02. It contains terminals and a
filter element for pressure compensation. A
suitable protective cover is available for
outdoor mounting.
Mounting example
Fig. 10: Mounting example: VEGAWELL S 51 in a pump shaft with
breather housing VEGABOX 02
3.2 Mounting steps with straining clamp
Fig. 11: Straining clamp
1
Suspension cable
2
Suspension opening
3
Clamping jaws
Mount VEGAWELL S 51 with straining clamp as
follows:
Hang the straining clamp on a suitable wall
1
hook
VEGAWELL S 51
1
2
3
Lower VEGAWELL S 51 to the requested
2
height
Slide the clamping jaws upward and push the
3
suspension cable between them
Hold the suspension cable, push the clamping
4
jaws downward and fix them with a light blow
Removal is carried out in reverse order.

3.3 Mounting steps with screwed

connection
Fig. 12: Threaded fitting
1
Suspension cable
2
Seal screw
3
Cone bushing
4
Seal cone
5
Threaded fitting
6
Seal
Mount VEGAWELL S 51 with screwed connection
as follows:
Weld the welded socket into the vessel top
1
Lower VEGAWELL S 51 to the requested
2
height by means on the welded socket G1½ A
or 1½ NPT on the vessel side
Insert the suspension cable from below into the
3
open screwed connection
Slide the seal cone and the cone sleeve over
4
the suspension cable, fasten manually with the
seal screw
Screw the screwed connection into the socket,
5
fasten with SW 30 and then fasten seal screw
with SW 19
How to correct the height:
Loosen seal screw with SW 19
1
Mounting
1
2
3
4
5
6
17