Operating Instructions; Switch On And Off - Flex L3309-115 Bedienungsanleitung

Angle grinder L3309-115/125/FR, L3410FR/VR, L3325FR

Operating instructions

Danger!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Before switching on the angle
grinder
Unpack the angle grinder and check that
there are no missing or damaged parts.

Switch on and off

Brief operation without engaged switch
rocker:
– Push the switch rocker (1) forwards and
hold in position.
– To switch off the angle grinder,
release the switch rocker (1).
Continuous operation with engaged switch
rocker:
– Push the switch rocker (1) forwards and
engage by pressing the front end.
To switch off the angle grinder, release the
switch rocker (1) by pressing the rear end.
Note
Following a power failure, the switched on
power tool does not restart.
Preselecting the speed
(L3410VR only)
To set the operating speed, move the dial
(9) to the required value.
Caution!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
Note
If an overload or overheating occurs during
continues operation, the power tool
automatically reduces the speed until the
power tool has cooled down adequately.
17