Programming Mode; Activating Programming Mode - Disty distybox 300 Bedienungsanleitung

EN
NOTE
NOTE
NOTE
NOTE
20
7. The registration process has been successful if the LED
flashes at intervals of approx. 10 seconds.
If the registration process has not been completed successfully
within approx. 3 minutes, register the device manually in

programming mode.

Programming mode
Programming mode on the
within the first 10 minutes after plugging in the power supply
unit. This prevents the parameters being changed accidentally
during operation.

Activating programming mode

To put the
distybox 300
as follows:
1. Connect your telephone to the
2. Connect the power supply unit to your
3. Plug the power supply unit into a power socket. Leave the
phone on the hook for at least 30 seconds.
4. Lift the handset on your telephone. Depending on whether
or not your distybox
station, you will either hear a busy tone or a dialling tone.
5. On your telephone, enter:
6. You will hear a positive acknowledgement tone.
Optional step:
7. Enter the PIN for the
telephone.
The PIN only needs to be entered if a new PIN has been set up
beforehand in programming mode.
Access to programming mode can be protected using the PIN!
distybox can only be activated
300
into programming mode, proceed
distybox
300
distybox
is already registered on a base
300
* * 9
distybox
.
.
300
300 via your
Operating instructions