Distybox 300; Automatic Registration - Disty distybox 300 Bedienungsanleitung

4. Connect the
5. Fit
The
"Programming mode" allows you to set various parameters

Automatic registration

The
To do this, the PIN on your base station must be set to "0000"
1. Connect the power supply unit (adapter) to your
2. Connect your telephone to the
3. Ensure that your base station enables an additional
4. During the registration process, the
5. Start the registration procedure for the device on your
6. Plug the power supply unit into a power socket.
Operating instructions
distybox
in place.
distybox 300
distybox must be registered on your DECT / GAP base
300
station before it can be used. The registration process can
normally be carried out using the "Automatic registration"
function.
to modify the distybox
base station. Additional parameters allow the distybox to be
set according to your personal preferences. Manual registra-
tion can also be carried out in this mode.
can be registered automatically, assuming
distybox 300
it has not been registered on any other base station yet.
or "1111".
.
distybox 300
handset on the hook.
cordless phone to be registered.
located close to your base station.
DECT / GAP base station as if you were registering an
additional cordless unit. Instructions on how to do this
will be given in the operating manual for your base station.
The registration process will be started automatically.
to the power supply.
300
to suit the functionality of your
300
distybox 300
distybox
, leaving the
should be
300
19
EN