Disty distybox 300 Bedienungsanleitung Seite 18

EN
SELECTING
A SUITABLE
LOCATION
NOTE
RADIO
COVERAGE
WALL
MOUNTING
18
Mounting
The is designed for wall mounting in interior
distybox 300
rooms.
Please note that the device must not be fitted in the immediate
vicinity of any other electronic devices such as hifi systems,
office machines or microwave ovens. This prevents any inter-
ference between the devices. In addition, the device should
not be installed near heat sources (e.g. radiators or in direct
sunlight).
To prevent noise interference when making calls, the
connected terminal should not be positioned closer than
one metre away from the
The distybox must be able to establish a radio link to the
300
DECT base station. Before determining the final mounting
position, you should therefore check that your desired location
is within the range of the DECT base station. Owing to the
digital transmission in the frequency range used, there may
be radiowave "blind spots" even within the specified range,
depending on the nature of the building. This results in
a loss of transmission quality. However, just a small change
in position will restore normal transmission quality. As the
works as a cordless unit on your DECT base
distybox 300
station, you can use your cordless handset to check whether
or not the mounting position is suitable.
Follow the steps given below to install the
1. Drill two 6 mm diameter holes into
the wall at a distance of 60 mm
apart.
2. Insert the rawl plug and turn the
screws until they are approx. 5 mm
away from the wall.
3. Connect your terminal to the
distybox 300 .
distybox 300 .
distybox
300
60 m
Operating instructions