Connection To 40 An Isdn/Analogue Line - Disty distybox 300 Bedienungsanleitung

EN
22
If during programming no input is made for one minute, the
procedure is cancelled and you will hear the special dialling
tone again.
Programming mode can be exited at any time by replacing
the handset; the distybox
mode.
Function
Manual registration
of the
distybox
300
The base station PIN needs to be entered to register the
distybox 300 . A PIN with 0 to 8 digits will be accepted by the
distybox . After entering
300
acknowledge tone. Leave the handset off hook and wait
until you hear again the special dial tone, which means that
the registration is completed. If the registration process has
not been completed successfully within approx. 3 minutes,
crosscheck the settings of the base station and try again.
Access to programming mode can be protected using the
four-digit PIN.
Connection to
an ISDN/analogue
line
This setting has to be used if your base station is connected
to an ISDN phone line. Send Keypad Information, while
connection Keypad information will be suppressed, so it is
possible to transmit DTMF signals.
Suppress Keypad Information: This setting has to be used if
your base station is connected to an analogue phone line.
will then be returned to normal
300
Parameter
code
1
# you will hear the positive
40
40
Other input
Base PIN #
0 #
1 #
Operating instructions