Setting The Time Zone - Grundig Sonoclock 795 DCF Bedienungsanleitung

SETTINGS
Setting time and day of the
week
If the device has been switched on
for the first time – if no time signal
has been received – »
in the display as a sign that the time
has to be set. The same applies after
a power failure or if the device has
been disconnected from the mains
supply and no back-up battery has
been inserted.
1 Press »SET«.
– Display: » « flashes.
:
2
Press »HOUR/VOL+« briefly to
set the hours step-by-step or hold
down to run through the hours
continuously.
3
Press »MIN/VOL-« briefly to set
the minutes step-by-step or hold
down to run through the minutes
continuously.
Notes:
When the minute display chang-
7
es from »
59
not affect the hour display.
The device saves the set time
7
automatically after 10 seconds.
4
To set the day of the week, press
ZONE/WEC« and »SET«
»TIME
at the same time.
– Display: for example, the day of
the week »
1
________________________________________
« appears
0:00
« to » «, this does
00
« = Monday.
5 Set the day of the week (»
Monday, » «, »
2
or » « = Sunday) using
7
VOL+« or »MIN/VOL-«.
– The device saves the selected
day of the week automatically
after 5 seconds.
Note:
Display the selected day of the
7
week and press »SNOOZE«
longer than 3 seconds and hold
it pressed.

Setting the time zone

If you use the device outside of the
Central European Time Zone (CET),
you can correct the time by +/– 2
hours.
1
Press »TIME
pressed for approximately 2 se-
conds.
– Display: »
00
2 Set the time zone with
VOL+« or »MIN/VOL-« (Scale:
» «, » «, »
00 01 02
– Display: e.g. »
«, » «, » «, »
3 4 5
»HOUR/
ZONE/WEC« keep
«, » « flashes.
:
»HOUR/
«, » « and »
-02 -01
«.
02
ENGLISH 21
« =
1
«
6
«).