Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance; Troubleshooting; Service Information - OHAUS Scout SKX Serie Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Scout SKX Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 54
TM
SCOUT
SERIES BALANCES - SKX

5. MAINTENANCE

5.1 Cleaning
WARNING: Electric Shock Hazard. Disconnect the equipment from the power
supply before cleaning. Electric Shock Hazard.
The housing may be cleaned with a cloth dampened with a mild detergent if necessary.
Attention: Do not use solvents, chemicals, alcohol, ammonia or abrasives to clean the housing
or control panel.

5.2 Troubleshooting

The following table lists common problems and possible causes and remedies.
If the problem persists, contact OHAUS or your authorized dealer.
Symptom
Cannot turn on
Poor accuracy
Cannot calibrate
Err 8.1
Err 8.2
Err 8.3
Err 8.4
Err 8.5
Err 8.6
ref.err
Lo.ref
CAL E
USB.Err

5.3 Service Information

If the troubleshooting section does not resolve or describe your problem, contact your
authorized OHAUS service agent. For service assistance or technical support in the United
States call toll-free 1-800-672-7722 ext. 7852 between 8:00 AM and 5:00 PM EST. An OHAUS
product service specialist will be available to provide assistance. Outside the USA, please visit
our web site, www.ohaus.com to locate the OHAUS office nearest you.
5.4 Accessories
DESCRIPTION
RS232 kit
USB Host kit
USB Device Kit
Bluetooth Kit*
Ethernet Kit
Stacking Kit, x6
Note: * Bluetooth kit is only available in certain regions according to the local regulations.
TABLE 5-1
Possible Cause
No power to balance
Improper calibration
Unstable environment
Security switch in locked position
Weight exceeds power on zero range.
Weight below power on zero range.
Over load (weight exceeds rated capacity)
Under load (pan removed)
Tare out of range
Displayed value exceeds 999999 (possible in Totalization mode)
Parts counting or percentage error – sample weight <1d. Balance
shows error then exits parts counting or goes to [Clr.ApU].
Percent Reference weight or APW is too low for accurate results
Fail to do calibration.
Cannot find menu or app file in U-disk.
TABLE 5-2. ACCESSORIES
Item Number
30268982
30268983
30268984
30268985
30268986
30268987
DESCRIPTION
Stacking Kit, x1
Specific Gravity kit
Auxiliary Display Kit
Carrying Case
In-Use Cover
Printers and Cables
EN-11
Item Number
30268988
30269020
30269019
30269021
30269022
Contact OHAUS

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis