V-ZUG GK45TEVC Installationsanleitung Seite 15

Installation instructions
Glass ceramic hob Toptronic
With normal mounting frame
Installation
GK45TEC
A
Centering mark,
middle of cut-out
Aim for a
max. of R10
With wood worktops
1. Create the installation cut-out accurately.
2. Centre mounting rails A and B and fix in the cut-out with the wood screws C according to the drawing above.
3. Where necessary establish mains supply connection before inserting the appliance.
4. Lower the appliance symmetrically into the cut-out as far as the worktop, on to the spring catch elements.
The connection cable is not to touch the hot parts of the metal tray under the cooking zones.
With stone worktops
With stone worktops, mounting rails A and B can be bonded in place (for adhesive see «Accessories»).
1. Clean/prime the bonding surfaces on the stone and the mounting rails then allow to dry thoroughly.
2. Apply the adhesive to the stone and smooth with the spatula. Apply a thin coating of the activator to the bonding surface of
the installation rails.
3. Position the installation rails centrally and press well in. Comply with the recommended bonding time for the utilized
adhesive.
4. Where necessary establish mains supply connection before inserting the appliance.
5. Lower the appliance symmetrically into the cut-out as far as the worktop, on to the spring catch elements.
The connection cable is not to touch the hot parts of the metal tray under the cooking zones.
Cable length 1.5 m
Centering marks,
C
B
Set of fixing brackets for
special installation cases
GK45TEVC / GK45TERC
front and rear
A
Aim for a
max. of R10
J417.00 6
26.5.08 ITH
Cable length 1.5 m
GK45TEVC
Centering mark,
middle of cut-out
GK45TERC
B
Centering marks,
front and rear
15/16