Operating Instructions - Nutricia Flocare Infinity PLUS Gebrauchsanleitung

Solely for the benefit of the original buyer/user, Nutricia Medical Devices B.V, warrants all new Flocare® Infinity™ pumps, of
its manufacture to be free from defects in material and workmanship, excluding normal wear and tear, and will replace or
repair, at its service facility or other location designated by Nutricia Medical Devices B.V, any Flocare® Infinity™ pump returned
to it within thirty-six (36) months of original purchase by the buyer/user. Such repair or replacement shall be free of charge.
Nutricia Medical Devices B.V warrants to the original buyer/user, all repaired or replaced pumps to be free from defects
in material and workmanship and will replace or repair such products, at its service facility or other location designa-
ted by Nutricia Medical Devices B.V. Such repair or replacement shall carry a warranty of ninety (90) days from the
date of repair or replacement or the balance of the new pumps warranty as described above, whichever is greater.
THIS WARRANTY APPLIES ONLY TO FLOCARE® INFINITY™ PUMPS MANUFACTURED BY NUTRICIA MEDICAL
DEVICES B.V AND IS THE ONLY WARRANTY GIVEN WITH RESPECT TO THE PUMPS. NO WARRANTIES IMPLIED
IN LAW, INCLUDING, BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
PARTICULAR PURPOSE, SHALL APPLY. NUTRICIA MEDICAL DEVICES B.V WILL BE LIABLE, IN ANY EVENT, ONLY
FOR THE PURCHASE PRICE OF THE DEFECTIVE PRODUCT, BUT NOT FOR ANY CONSEQUENTIAL DAMAGES.
This Warranty may not be modified, amended or otherwise changed, except by a written document properly executed by a corpo-
rate officer of Nutricia Medical Devices B.V
THE WARRANTY IS VOID IF THE FLOCARE® INFINITY™ PUMP IS SUBJECT TO ABUSE, ACCIDENT, ALTERATION, MODIFICATION,
TAMPERING, MISUSE OR THE UNAUTHORIZED REPAIR OR SERVICE IN ANY WAY WITHOUT PRIOR AUTHORIZATION FROM
NUTRICIA MEDICAL DEVICES B.V. IN ANY EVENT, NUTRICIA MEDICAL DEVICES B.V.'S LIABILITY SHALL NEVER EXCEED
THE ORIGINAL PURCHASE PRICE OF THE PUMP AND SHALL NOT EXTEND TO ANY CONSEQUENTIAL LOSS OR DAMAGE.
• Connect the set to the feed container as instructed on the packaging of the Flocare
Remove the dust cap from end of pump set.
• The Flocare ® Infinity
the set has no roller clamp.
Fill the pump set completely with feed by gently pinching on the side of the cassette that is marked with a
drop (point A on figure 5a) or fill the pump set with help of the pump (see paragraph: filling the pump set).
• Open the pump door by pressing up on the lower wall and rotating the door upwards at the same time
(see figure 5b).
• Position the looped section of the silicone tubing around the rotor.
Stretching lightly, (see figure 5c) seat the cassette into the pump (see figure 5d).
• Close the pump door
ZMNL900617_AW.indd 80
Limitations of warranty

OPERATING INSTRUCTIONS

INSERTION OF THE FLOCARE
™ + pump sets are equipped with an "automatic free-flow protection", as a consequence
SWITCHING "ON"
For proper pump operation, make sure the pump door is closed prior to switching the
pump on by holding the "ON/OFF" key for 2 seconds otherwise the pump will gene-
rate an error.
The pump beeps and carries out a short self test, showing the pump serial number
in 8 digits. Verify that all display segments and symbols are active as shown in figure
6 (see next page).
The pump displays the total volume delivered since the memory was cleared and
switches in the hold mode ready for programming.
SWITCHING "OFF"
Press the key and keep it pressed for 2 seconds. A continuous alarm will be heard
and the pump switches off.
INFINITY PUMP SET
® ™
-80-
UK-IE
Infinity pump set.
® ™
10/11/16 16:17
a
T
t
E
P
a
t
T
a
T