REPLACING THE LED LAMP
IMPORTANT: Before replacing the lamp, make sure that
1. Remove the protective cover by prising it off at the sides, using a
slim screwdriver (see fig. 4 a).
2. Unscrew the 2 screws (A) fig. 4 b fastening the LED lamp support
to the lamp holder.
3. Disconnect the input connector on the end of the cable from the
support containing the LED lamps
4. Insert the connector on the cable into the new LED lamp support.
Be careful to insert it in the correct direction.
5. Line up the LED light support to the supports in the lamp holder
and fix into place with the screws (A) fig. 4 b.
6. Press the cover of the lamp holder back into place.
fig 4.a
the refrigerator is not connected to the mains
power and if necessary, remove the plug from
the mains socket. The LED lamp must only be
replaced by qualified persons who are able to
take all of the required safety precautions.
fig 4.b
25
EN