Transferring Measurements To A Pc - Easy Fit; Starting The Software - Beurer BF 100 Body Complete Gebrauchsanweisung

12 Transferring measurements to a PC – Easy Fit
The EasyFit software gives you optimum
evaluation of your data. You can monitor
your weight and analysis data over a long
period, display it in the form of graphs and
have it evaluated.
If you combine it with a Beurer heart rate
monitor, you will find that there are many
other functions for weight management
and planning your training sessions:
x Calendar functions
x Transfer all data recorded during train-
ing sessions
x Weekly training plan to help you reach
your desired weight
x Different analyses and graphs for moni-
toring your training progress.
Notes:
x Effective evaluation of the measured
values is only possible if you have
set the date and time correctly.
x It is not possible to take any meas-
urements while the data is being
transferred.
x The measurement data remains on
the control unit even after being
transferred to the PC.
x If the 30 memory locations for a user
are full, "MEMORY_FULL" appears
on the display. The control unit re-
members the data that has just been
transferred. Therefore, if another 30
new memory locations for a user are
full, "MEMORY_FULL" appears on
the display again.
x You can, however, also transfer
individual measurement values at
any time.
Operation
x Install the analysis software on your PC
as described in the instructions for the
PC software.
x The control unit must be in standby
mode (date and time displayed). Insert
the flat USB connector of the connec-
tion cable into a USB port on your PC.
Plug the smaller mini USB plug into the
USB connection on the right-hand side
of the control unit.
x "CONNECTED VIA_USB" is shown on
the display and an audible signal
sounds from the PC. When first con-
nected, a "USB HID" is automatically
installed. The control unit is now ready
to transfer data for 30 seconds.

Starting the software

You can start the EasyFit software by
either double-clicking on the EasyFit icon
or via the Start menu. When starting the
software for the first time, please enter
your personal details under New regis-
tration, and confirm them by clicking
"Save".
39