ECG FT 23a Bedienungsanleitung Seite 31

Cleaning and maintenance operations must not be carried out by
children unless supervised by an adult.
Make sure that the power cable or extension cord can not be
accidentally pulled out of the socket during operation.
Use the handle to carry the appliance.
Warning: To prevent overheating, do not cover the fan.
DANGER FOR CHILDREN: Children must not play with the packaging
Installation FT 23a – see fig. A
1. Unscrew the rear grille attachment nut (3) by turning it counterclockwise.
2. Place the rear grille (4) against the motor cover (6) with the handle up. Make sure the guide pins of the
motor cover are properly inserted into the grille holes.
3. Screw the nut for attaching the back grille (3) firmly by turning it clockwise.
4. Remove the plastic protector from the motor shaft (5).
5. Insert the propeller (2) onto the motor shaft (5) by gently sliding it onto the motor shaft guide pin.
6. Attach the front grille (1) to the back grille (4).
7. Turn the clamps in the grille frames and join the grilles firmly together.
Installation FT 30a/FT 40a – see fig. B
Unscrew the nut that attaches the propeller (2) from the motor (6) shaft by turning it clockwise.
1.
2. Continue by unscrewing the nut that attaches the back grille (4) by turning it counter-clockwise.
3. Place the rear grille (5) against the motor cover (7) with the handle up. Make sure the guide pins of the
motor cover are properly inserted into the grille holes.
Screw the nut for attaching the back grille (4) firmly to the motor by turning it clockwise.
4.
5. Remove the plastic protector from the motor shaft (6).
6. Insert the propeller (3) onto the motor shaft (6) by gently sliding it onto the motor shaft guide pin.
Screw the nut for attaching the propeller (2) to the motor shaft by rotating it counter-clockwise and
7.
tighten firmly.
8. Attach the front grille (1) to the back grille (5).
9. Turn the clamps in the grille frames and join the grilles firmly together.
Base installation
This fan includes a shaped base (11), which must be installed prior to using the fan for the first time. The shaped
base comes with 4 screws (in a small bag taped to the bottom side of the shaped base).
Remove the bag of screws and place the shaped base on the base pins and snap on. Make sure the shaped base
is secured by the pins on the fan base and screw the 4 included screws into the holes in the middle of the base.
Do not tighten the screws too tightly.
HEAT PROTECTION
Heat protection is activated if an actuating unit is overloaded. The fan switches off automatically. In this case,
refer to a professional service centre.
Do not immerse in water!
material. Do not let children play with the
plastic bags. Risk of suffocation.
GB
31