Sabre 1336HR Betriebsanleitung Seite 73

MAINTENANCE
try to repair them! ALWAYS USE MANUFACTURER'S GENUINE SPARE
BLADES !
ATTENTION!
!
ted sequence, making sure that the blades' wings are facing towards the
interior of the deck cutting deck and that the concave part of the flexible
washer (1) is pressing against the blade. Fully tighten the fixing screws
(2).
Vertical positioning
ATTENTION!
!
one person and should only be done on a hard level surface.
If you need to get to underneath the lawn-
tractor, it is possible to lift it up into a verti-
cal position after having removed the
grass-catcher or stone-guard, and having
made sure that there is less than 2 litres
of fuel in the tank.
Make sure that the machine rests on the
indicated points, inserting a wedge (1) of
about 120 mm beneath the lower edge of
the plate and taking care to not damage
plastic parts and the supports for the
grass-catcher.
DANGER!
!
stability of the lawn-tractor before
carrying out any type of work on the
machine and avoid operations which
may cause it to fall over.
When reassembling the blades, always follow the indica-
Vertical positioning is best accomplished by more then
Be sure of the good
1
120 mm
1
eng 33
1