Sabre 1336HR Betriebsanleitung Seite 71

MAINTENANCE eng 31
Cutting deck adjustment
The cutting deck should be parallel with the
ground to obtain a good cut.
Height adjustments to the cutting deck are
made through three linkages.
Such adjustments are to be made on a flat
surface after having ensured that the tyre
pressures are correct.
2 1
Height is regulated through the adjusting nut
(1).
If the cutting deck is not parallel, adjust the
nuts (2) of the rear linkage until the edge of
the deck is the same distance from the floor
on both sides.
Adjust the nuts of the front tensioner (3) until
the front edge of the deck has the same
distance from the floor as the sides. 3
This distance is to be checked at two or
three different heights, and carried out either
with the user seated or otherwise without the user in position but keeping the rear
edge 3 mm higher than the front.
NOTE
For achieving good results from cutting, the front part should
always be 2 - 4 mm lower than the rear.
If you are unable to get the cutting deck parallel, consult your Dealer.
Brake adjustment
If the brakes should seem to be weak, immediately seek advice from your Dealer.