Cleaning And Storage - Sabre 1336HR Betriebsanleitung

HOW TO USE THE MACHINE
ATTENTION!
!
position for 20 seconds before stopping the engine.
ATTENTION!
!
tor unattended!

5.4 CLEANING AND STORAGE

Cleaning
After each mowing, clean the outside of the lawn-tractor, empty the grass-catcher
and shake it to remove residual grass and earth.
Clean the plastic parts of the body with a damp sponge using water and deter-
gent, taking care not to wet the engine, the electrical parts or the electronic card
located under the dashboard.
IMPORTANT
body and engine!
Washing the inside of the cutting deck
The lawn-tractor has to be put on firm ground with the stone-guard or grass-cat-
cher in position. Washing the inside of the cutting deck and the collector channel
is done by connecting a water hose to each of the fittings (1) one at a time, and
running water through for a few minutes each, with:
– the operator seated,
– the engine running,
– the gear in neutral,
– the parking brake on,
– the blades engaged.
When washing, the cutting deck should
be in the fully lowered position.
Take off the grass-catcher, empty and
rinse it, and then put it in a position to
assist quick drying.
To avoid backfire, put the accelerator in the «SLOW»
Always take out the ignition key if leaving the lawn-trac-
Never use hoze-nozzles or harsh detergents for cleaning the
1
eng 25