Starting And Moving - Sabre 1336HR Betriebsanleitung

HOW TO USE THE MACHINE

5.2. STARTING AND MOVING

Starting
DANGER!
!
well ventilated area! ALWAYS REMEMBER THAT EXHAUST GASES ARE
TOXIC!
Before starting the engine:
– Open the fuel stop-cock (1);
– Ensure that the drive pedal is in neutral («N»);
– On slopes, engage the parking brake;
– Put the blade engagement lever into the disengage
position («A»).
Afterwards:
– Put the accelerator lever to «CHOKE» shown on the
label if the engine is cold. If the engine is already
warm, put the lever between «SLOW» and «FAST»;
– Put in the key and turn to «ON» to make electrical
contact, then turn to «START» to start the engine.
Release once the engine has started.
When the engine is running, put the accelerator into the «SLOW» position.
NOTE
the starter motor for a long time as this can run down the battery or flood the
engine. Turn the key to the «OFF» position, wait for a few seconds and then
repeat the operation. If the malfunction continues, refer to chapter «7» of this
manual and to the engine booklet.
IMPORTANT
ne starting when:
– the blades are engaged
– the transmission is not in neutral («N»).
– the operator is absent with the parking brake disengaged.
The pilot lamp will begin flashing if the key is held in the «START» position
when the safety devices have been activated.
NOTE
when the parking brake is on, the engine stops.
All starting operations have to be effected in an open or
Should you have difficulties in starting do not continue to use
Always bear in mind that the safety devices prevent the engi-
If the drive pedal is used for forward or reverse movement
eng 19
1