Grass Cutting - Sabre 1336HR Betriebsanleitung

eng 20
Moving without mowing
NOTE
ged and the cutting deck put at its highest position (position «7»)
Put the accelerator control in a position between «SLOW» and «FAST».
Keeping the brake pedal pressed, disengage the parking brake and then release
the pedal.
Press the drive engagement pedal in the «F» direction and go to the required
speed by progressively increasing pressure on the pedal and moving the accele-
rator appropriately.
The pressure on the pedal must be gradually applied as a sudden engagement of
drive to the wheels may cause tipping and loss of control of the lawn-tractor.
ATTENTION!
!
public roads. It has to be used (as indicated by the highway code) in pri-
vate areas closed to traffic.
Braking
To brake, release the drive pedal which will go into the «N» position, causing the
lawn-tractor to slow down considerably. Then press the brake pedal to further
reduce the speed until the lawn-tractor stops.
Reverse
Reverse can be engaged ONLY when the lawn-tractor is stopped. When the
lawn-tractor is stopped, start the reverse movement by pressing the drive pedal in
the «R» direction.

5.3. GRASS CUTTING

Engaging blades and forward movement
When you have reached the area to be mowed,
– put the accelerator into the «FAST» position;
– engage the blades by putting the lever into position «B»;
When moving the lawn-tractor, the blades must be disenga-
The lawn-tractor has not been approved for use on
HOW TO USE THE MACHINE