Unpacking And Assembly; Fitting The Steering Wheel - Sabre 1336HR Betriebsanleitung

UNPACKING AND ASSEMBLY

3. UNPACKING AND ASSEMBLY
For storage and transport reasons, some components of the lawn-tractor are not
directly installed in the factory, but have to be assembled after their removal from
the packing. Final assembly is carried out by following these simple instructions.
IMPORTANT
engine oil or fuel. Before starting up the engine, fill with oil and fuel following
the instructions given in the engine booklet.
UNPACKING
When unpacking the machine, take care to gather all individual parts and fittings,
and do not damage the cutting deck when taking the lawn-tractor off the base
pallet.
NOTE
move it, the drive disengage lever should be put in position «B» (see chap. 4 n.
13).
The standard packing contents:
– the lawn-tractor;
– steering wheel;
– seat;
– grass-catcher components and support brackets for the frame;
– an envelope containing the instruction manual, documents and the nuts and
bolts with two starter keys, a pin for blocking the steering wheel and a spare
7.5 A fuse.

FITTING THE STEERING WHEEL

Put the lawn-tractor on a flat surface and
straighten up the front wheels.
Fit the steering wheel (1) onto the protru-
ding shaft (2) with the spokes directed
towards the seat.
Line up the hole in the steering wheel hub
with the hole in the shaft and insert the
pin supplied (3).
For transport reasons the lawn-tractor is supplied without
To make it easier to get the lawn-tractor off the pallet and to
eng 9
2 3 1