Setting Up And Connecting The Appliance - Dometic D15 Bedienungsanleitung

Setting up and connecting the appliance

7 Setting up and connecting the
appliance
7.1 Notes on setting up the appliance
All models can be set up on a fitted or free-standing basis.
When selecting the location, observe the following instructions:
The ambient temperature should be in the range specified for your country in the
supplementary "Country versions" booklet. Otherwise, it could mean that the
inner temperature you set cannot be reached or maintained. This could also be
the case if there are extreme fluctuations in the ambient temperature
The appliance should stand in the coldest part of the room, away from heat
sources (ovens, heating devices or radiators).
The location must not be damp or wet.
The appliance must not be exposed to direct sunlight. This can damage the
acrylic coating and lead to higher power consumption.
The ground must be level and sufficiently stable to bear the appliance at full
capacity.
The appliance must be sufficiently ventilated. The ventilation slots on the front of
the appliance must not be obstructed.
Note the information on the electrical connection, see chapter "Information on
electrical connection" on page 17.
Remove all the inner and outer packaging materials before setting up.
Make sure the appliance is level by adjusting the feet.
7.2 Notes on installing the appliance
The models can be installed in a kitchen unit under the counter.
Width
Depth
Height
16
Installation size (in mm)
D15 D50
300 600
590 590
870 870
D15, D50, D52
D52
600
575
865
EN