Hamilton KHAKI X-Wind Bedienungsanleitung Seite 5

Leather straps
Hamilton recommends that you follow the steps below
in order to preserve the condition of your leather strap
for as long as possible:
• Avoid contact with water and dampness to prevent
discoloration and deformation.
• Avoid prolonged exposure to sunlight to prevent the
color from fading.
• Do not forget that leather is permeable ! Therefore
avoid contact with greasy substances and cosmetic
products.
• If you have a problem with your leather strap, please
contact your nearest Hamilton retailer.
Magnetic fields
To prevent malfunctions of your watch avoid coming
into contact with magnetic fields such as those of mag-
nets, loudspeakers, cell phones, refrigerators, etc.
Operating instructions
Movement
Your watch is fitted with an automatic movement. The
mechanism of the watch includes an oscillating rotor
that winds the mainspring via the motion of your wrist.
The power reserve is up to 60 hours.
If necessary, the movement may be rewound manually
by turning the crown clockwise 30 times in position (I).
With most of our models, the beauty of the inner work-
ing of the watch movement can be admired through
the transparent case back.
INSTRUCTION MANUAL
The Hamilton Khaki Automatic X-Wind has three screw-down
crowns and two push-buttons.
Important: to keep your watch water-resistant, always
screw the crowns , , and
A D
all the settings.
Setting the time
1. Unscrew setting crown
2. Pull out the crown completely to position (III).
3. Adjust the time by turning the crown in the desired
direction.
4. Push back the crown completely then screw it down
again.
Setting the date / day
1. Unscrew setting crown
2. Pull out the crown to the intermediate position (II).
3. Turn the crown anticlockwise until the desired date
appears, or clockwise for the desired day. Do not
perform this operation between 20:00 and 02:00
(8 p.m. and 2 a.m.).
4. Push back the crown completely then screw it down
again.
Chronograph functions
Simple or added timing
1. Press button to start the chronograph.
B
2. Press button again to stop the chronograph. The
B
elapsed time or the first partial time is indicated by
the hands of the counters
3. Repeat these two steps for each additional timing.
At the end of the last timing, the chronograph will
indicate the cumulative time of all the partial timings
added together.
4. Push button to reset the counters to zero.
C
back to position (0) after
E
.
A
.
A
, and .
4 5 6
3