Team Kalorik TKG EXP 1000 Gebrauchsanleitung Seite 16

Fax +32 2 359 95 50

12. After about 2-3 minutes the water reaches the good temperature and flows through the
coffee grinding in the jug.
13. When the coffee production is completed, turn the selector knob to 0/OFF position. The
pilot light goes off indicating that the appliance is turned off.
14. Before removing the filter holder, make sure there is no more pressure in the tank (as
described in the section "SPECIAL SAFEGUARDS CONCERNING STEAM UNDER PRESSURE").
Caution
Be careful when you remove the filter holder because the metal parts could be still hot. To
remove the filter holder, turn it to the left until the filter holder comes out of the appliance.
Attention: Make sure that the tank is empty and that there is no more steam under pressure.
Remove the filter holder. Place the filter locking flap (so that the filter doesn't fall) and empty
the coffee grinding from the filter.
HOW TO PREPARE A CAPPUCCINO
1. To make cappuccino, the first step is making espresso (see section "preparing espresso
coffee").
2. When the espresso is ready, put the selector knob in 0/OFF position.
3. Fill the half or the third of a small container with fresh full-cream milk.
4. To froth the milk, place the container with the milk under the pipe, plunge the steam pipe
in the milk and put the selector knob in
depending on how much froth you need and what type of milk you are using.
To obtain a smooth froth immerse the steam pipe for about 3 cm in the milk. Lift and lower
the container but without immersing the pipe more than 3 cm in it. Do not bring the milk to
the boil. Caution: the steam pipe should not touch the bottom of the receptacle as this
might obstruct the steam flow.
5. Once the froth is obtained, shut off steam by putting the selector knob in 0/OFF position.
6. Pour the espresso coffee in the breakfast cups and add the froth on the espresso with a
spoon.
CLEANING
Before cleaning the appliance, switch it off, remove the plug from the wall socket and wait
until it cools down. The filter, the filter holder, the jug and its lid, the drip tray can be washed in
hot soapy water. Do not put them in the dish washer. Wipe the body of the appliance with a
damp cloth. Never immerse the body of the appliance in water or any other liquid. Clean the
support of the filter holder with a damp cloth too in order to eliminate the coffee residues. If
there is still water in the tank, let the appliance cool down, remove the tank cap, remove the
different parts and empty the tank by turning the appliance over a sink in order to empty the
remaining water.
Cleaning of the steam pipe
Wash the steam pipe after each use especially when it has been immersed in milk. If you do
not wash it, the inner side of the pipe can get blocked up and it will be difficult to remove the
milk residues around it. The plastic nozzle of the pipe can be removed for cleaning by simply
pulling it down. In case of obstruction of the pipe, use a needle to remove the milk residues.
Just after having lathered up the milk, wipe the body of the pipe with a damp cloth, then keep
the cloth against the opening of the steam outlet and put the selector knob in steam position
( ); let the steam escape for one or two seconds in order to throw out the milk residues and
then turn the knob back to 0/OFF position.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
position for approximately 45-60 seconds
16
Assembly page 16/48
TKG EXP 1000 - 160609