Special Safety Instructions - Ayce 1515 Originalbetriebsanleitung

f) Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
5) Service
a) Have your power tool serviced by qualified repair person using only
identical replacement parts. This will ensure that the safety of the power tool
is maintained.
b) If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.

SPECIAL SAFETY INSTRUCTIONS

1. Wear ear protectors with impact drills. Exposure to noise can cause
hearing loss.
2. Use auxiliary handles supplied with the tool. Loss of control can cause
personal injury.
3. Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the operator an electric shock.
4. If possible, always use clamps or a vice to hold your work.
5. Always switch off before you put the drill down.
6. Ensure that the lighting is adequate.
7. Do not put pressure on the drill, such that it slows the motor down. Allow the
drill bit to drill without pressure. You will get better results and you will be
taking better care of your tool.
8. Keep the area free of tripping hazards.
9. Do not let anyone under 18 years operate this tool.
10. Only use accessory bits in good condition.
11. Before drilling, check that there is sufficient clearance for the drill bit under
the workpiece.
12. Do not touch the bit after operation. It will be very hot.
13. Keep your hands away from under the workpiece。
14. Never use your hands to remove dust, chips or waste close by the bit.
15. Rags, cloths, cord, string and the like should never be left around the
work area.
16. If you are interrupted when operating the drill, complete the process and switch
off before looking up.
17. Periodically check that all nuts, bolts and other fixings are properly tightened.
18. When using the drill, use safety equipment including safety glasses or shield,
hearing protection, and protective clothing including safety gloves. Wear a
dust mask if the drilling operation creates dust.
The tool must be used only for its prescribed purpose. Any use other than those
mentioned in this Manual will be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury resulting from such cases of
misuse.
To use this tool properly, you must observe the safety regulations, the assembly
instructions and the operating instructions to be found in this Manual. All persons who
use and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards. Children and frail people
must not use this tool. Children should be supervised at all times if they are in the
area in which the tool is being used. It is also imperative that you observe the accident
prevention regulations in force in your area.
The same applies for general rules of occupational health and safety.
The manufacturer shall not be liable for any changes made to the tool nor for any
damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to eliminate all residual risk
factors.
The following hazards may arise in connection with the tool's construction and design:
● Damage to the lungs if an effective dust mask is not worn.
● Damage to hearing if effective hearing protection is not worn.
● Hand-arm vibration syndrome if its use is not adequately managed
74 | 75 GB