Ayce 1515 Originalbetriebsanleitung Seite 42

NOTE: The first time the tool is run after changing the direction of rotation, you
may hear a click on start up. This is normal and does not indicate a problem.
Hammer action selector (Fig. 6)
Fig. 6
Power on indicator (Fig. 7)
Fig. 7
ON/OFF switch (Fig.8)
Fig. 8
1. To select hammer action for drilling
in masonry, set the hammer action
selector fully to the symbol marked
with " ".
2. To select drill mode for drilling in
wood and metal, set the hammer action
selector fully to the symbol marked
with " ".
Your tool has a "Power on indicator"
light. This light is always on when the
tool is plugged into a power source.
1. Start the tool by squeezing the
variable speed trigger switch.
2. Release the trigger to stop the tool.
3. If you press the lock on button while
the trigger switch is depressed, the
switch is kept in the operating position.
This is convenient when continuous
operating for extended periods of time
is required.
4. To release the lock on button, press
and release the trigger switch.
3. Operation for working
a. general operation
1. Check the product, its power cord and plug as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
2. Double check that accessories or application tools are properly fixed.
3. Always hold the product by its handle. Keep the handles dry to ensure safe
support.
4. Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working with it
and when other people enter the working area. Always let the product come to
complete stop before putting it down.
6. Do not overwork yourself. Make breaks on regularly base to ensure
concentrated work and full control over the product.
Keep in mind that there are buried objects hidden in every household!
!
Ensure that there are no gas, water or power lines hidden in the
working area that may be hit before operation – danger of electrical
shock and serious damage to people and property! Use a suitable
detector to trace such objects in advance!
WARNING
b. Drilling
1. When attempting to drill a large diameter hole, it is sometimes best to start
with a smaller drill bit then work up to the required size. This prevents
overloading the drill.
2. Remember to use a "wood-pecker" action on deep holes to allow the swarf to
be ejected from the hole.
3. If the drill bit snags, switch off immediately to prevent permanent damage to
the drill.
4. Try running the drill in reverse to remove the bit.
5. Always keep the drill in line with the hole.
6. Ideally, the drill bit should enter at right angles to the work. If the angle is
changed during drilling, this could cause the bit to snap off blocking the hole
and perhaps causing injury.
7. Reduce pressure as the drill is about to break through the item being drilled.
Don't force the drill, and let it work at its own pace.
8. Keep the drill bit sharp.
82 | 83 GB