Operation - Ayce 1515 Originalbetriebsanleitung

Recycle unwanted materials instead of disposing of
them. All appliances and packaging should be sorted
and tendered at a regional recycling centre into to be
processed in an ecological manner.
2. Product symbols
In this manual and/or on the machine the following symbols are used. These
represent important information about the product or instructions on its use.
600W
Rated output
600W
230-240V~ 50Hz
Rated voltage
230-240 V~
50Hz
0-2900/min no load
min -1
speed
0-2900
13mm max. collet
diamater
Ø 13mm
10mm drill capacity
in metal
Ø 10mm
13mm drill capacity
in concrete
Ø 13mm
28mm drill capacity
in wood
Ø 28mm
3m cable with Swiss
plug
3M

OPERATION

1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
2. Functions
Inserting and removing a bit (Fig. 2)
Always ensure that the plug is disconnected from the power
!
source, the tool is switched off before inserting or removing
bits to prevent accidental starting.
WARNING
Fig. 2
Auxiliary handle and depth gauge (Fig. 3)
Always ensure that the drill is switched off and plug is re-
!
moved from the power point before making any adjustments.
WARNING
78 | 79
Your tool is fitted with a keyless chuck for
greater convenience, a chuck key is not
needed to secure a bit in the chuck.
The chuck also has a locking device to
prevent bits loosening in use.
1. To insert / remove a drill bit, depress
the spindle lock button with one hand,
use your other hand to rotate the sleeve
of the chuck in an anti-clockwise
direction.
2. Open the chuck jaws sufficiently so
as to fit the desired bit.
3. Insert the drill bit into the chuck and
tighten securely by depressing down
the spindle lock button of the chuck
and rotating the sleeve in the clockwise
direction until you hear a "click".
GB