Preparing The Product For Use; Replacing The Batteries - Silvercrest IAN 113060 Bedienungs- Und Sicherheitshinweise

If the above instructions are not complied
with, the batteries may discharge them-
selves beyond their end voltage. There is
then a danger of leaking. If the batteries
have leaked inside your device, you should
remove them immediately in order to pre-
vent damage to the device!
Avoid contact with the skin, eyes and
mucous membranes. Any parts of the body
coming into contact with battery acid
should be rinsed off with copious amounts
of water and / or a doctor contacted if
necessary!

Preparing the product for use

Remove the insulation strip from the battery compartment .
4
Replacing the batteries (Fig. B)
Open the battery compartment on the back of the scale.
4
Remove the used batteries, if present.
Insert 2 x 1.5 V AAA batteries into the battery compart-
ment .
4
Note: Make sure you fit the batteries the right way round
(polarity). The correct polarity is shown inside the battery
compartment .
4
Close the battery compartment .
4
44 GB/MT