Loading The Wheelchair - Autoadapt Carolift 90 Benutzerhandbuch

3. LOADING THE WHEELCHAIR

1.
Place the wheelchair/scooter in a suitable direc-
tion behind the vehicle bumpers.
Prepare the mobility device by folding down or
removing backrest or folding the cross-frame
wheelchair.
3.
Lower the docking device by pressing the control
button for lowering. Fasten the docking device to
the attachments in the wheelchair/scooter.
Make sure the wheelchair/scooter
is properly docked.
5.
Swivel the load inside, by pressing the control
button for swivelling inside. Hold, at the same
time, on to the load and guide it through the door
opening to a suitable position
in the luggage compartment.
6.
Lower the load, by pressing the
control button for lowering.
8
2. Swivel out the hoist by pressing the control button.
Make sure the hoist cord is as vertical towards
wheelchair balance point as possible, to avoid that
the wheelchair starts to swing when lifted.
4. Lift up the load by pressing the control button for
lifting. Hold on to the load and guide it passed the
rear of the vehicle, until it reaches slightly above
the lower edge of the door opening.
Do not lift the lifting device of the cord
beyond the yellow distance indicator.
Make sure the wheelchair/scooter is properly
7.
lowered and standing steady on the floor!
Keep the docking device fastened to the wheel-
chair with the cord slightly stretched.
Place the control pendant in it's holder, to prevent
the hoist from being accidently activated during
transport.
IMPORTANT! The load must be secured to
the vehicle compartment during transport.