Candy CS C7LF-S Bedienungsanleitung Seite 8

2. DRAIN HOSE : FITTING
INSTRUCTIONS FOR TANK
IN DOOR DRAWER
To avo d empty ng the water conta ner after
each dry ng cycle, the water can be d scharged
d rectly to a waste water dra n p pe (the same
dra nage system as household s nks). Water
Bye-Laws proh b t connect on to a surface
water dra n. The waste water dra n p pe should
be located adjacent to the tumble dryer.
The k t cons sts of:1 hose and 1 tap.
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit the Hose as Follows:
1.T lt the mach ne
backwards.
2. The waste water
p pe is situated at the
right-hand side of the
machine (see the
p cture). A grey hose
connects to the bridge
at the left hand s de of
the mach ne. Using
pliers, remove the
pipe retaining clip
from the bridge.
3. Pull the hose off the
bridge connection.
1
2
3
4. Attach the black
hose from the kit,
(using the connector
a n d p i p e c l i p s
supplied), to the hose
r e m o v e d f r o m t h e
bridge connection.
5 . P l a c e t h e t a p
suppl ed by the k t to
c l o s e t h e r e m a n g
hose.
Connect the new drain
hose to the waste
black water pipe .
6. Once the mach ne s
n place, check the
bottom to ensure that
the new hose does not
kink when pushing the
t u m b l e d r y e r i n t o
position.
Connect to the mains
electricity supply.
NOTE : The d rect dra n condensed
water k t s su table only on models w th the
water tank on the door
8
4
5
6