Replacing The Lamp; Closing The Door; Technical Data - AEG S53800KDW0 Benutzerinformation

34

Technical data

Problem
The temperature in the re-
frigerator is too high.

Replacing the lamp

1. Switch off the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of
the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the lamp cover).
4. Install the lamp cover by sliding it into
its original position.
5. Switch on the appliance.
6. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.
Possible cause
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
Height
Width
Depth
Solution
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
1800 mm
600 mm
650 mm