After Measurement; Troubleshooting - Viatom BP1 Handbuch

3. In some cases, if the APP judged that the pressure in the
cuff is not high enough for the measurement, then an
instruction of continuous pump will be issued. Just follow
the instruction.
4. The monitor will automatically deflate the cuff slowly
during the measurement, a typical measurement takes
about 30s.
5. The blood pressure readings will appear in the phone
when the measurement finished.
Note: During the measurement, you should keep still and don't
squeeze the bulb. Stop measuring when the indicator turns red.
Otherwise the measurement may be effected and the blood
pressure readings may be inaccurate.

3.7 After Measurement

Press the exhaust valve to exhaust air from the cuff.
Press the button to turn off the power after the
measurement. Remove the cuff.
Note: The device has an automatic power shut-off
function, which turns off the power automatically in two
minute after measurement.
Trouble Shooting
Problem
The monitor
cannot be
connected to
the phone
The monitor
don't
response to
the button
Possible Cause
The phone
Bluetooth is OFF
The phone doesn't
support the
Bluetooth 4.0 BLE
The monitor is
running in an
unexpected status.
8
Recommended
Action
Turn on the phone
Bluetooth from the
setting menu.
Change to a
compatible phone.
Reset the device by
press and hold the
button for 5s.