Specifications - Makita BHR200 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Battery cartridge
1-2. Red part
1-3. Button
2-1. Switch trigger
3-1. Reversing switch lever
4-1. Rotation with hammering
4-2. Lock button
4-3. Pointer
4-4. Change lever
5-1. Rotation only
5-2. Pointer
6-1. Hammering only
6-2. Pointer

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : hammer drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
7-1. Foot
7-2. Battery cartridge
8-1. Foot
8-2. Screw
8-3. Battery cartridge
9-1. Side grip
10-1. Bit shank
10-2. Bit grease
11-1. Bit
11-2. Chuck cover
13-1. Change lever
13-2. O symbol
14-1. Change lever
Model
Concrete
Steel
Wood
-1
)
Overall length
Net weight
Rated voltage
) : 87 dB(A)
pA
) : 98 dB(A)
WA
2
) : 14.0 m/s
h,HD
2
ENE043-1
Work mode : chiseling
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: drilling into metal
Vibration emission (a
ENG905-1
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
ENG900-1
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
4
15-1. Depth gauge
15-2. Clamp screw
15-3. Grip base
16-1. Dust cup
18-1. Blow-out bulb
20-1. Drill chuck
20-2. Change lever
20-3. Pointer
21-1. Limit mark
22-1. Brush holder cap
22-2. Screwdriver
BHR200
20 mm
13 mm
27 mm
0 - 1,100
0 - 4,700
316 mm
3.8 kg
D.C. 24 V
) : 12.0 m/s
h,CHeq
2
2
) : 2.5 m/s
h,D
2
2
ENG901-1